Dehumidifier Recusorb R-51/61R Manufactured in stainless steel, these units include internal heat recovery, electric reactivation and Auto-Manual mode switching. Pre-wired for simple humidistat control as standard, units are also available for two 2 step binary control (from EH4 2 step controller) or linear capacity control (from EH3 PI controller or BMS control signal)..
Dehumidifier Recusorb R-51/61R:
- Highly efficient D-MAX rotor
- No desiccant carry-over
- Stainless steel chassis
- Built-in heat recovery
- Low dry air temperature
- Long lifetime
Recusorb R operates using integrated heat recycling. During the rotor’s regeneration (green), heat is absorbed, and then recycled in the “purge zone”, where incoming air is pre-heated and partly dehumidified. Energy consumption falls and the dry air becomes both drier and cooler compared to other sorption dehumidifiers.Section of a dehumidifier rotor from Seibu Giken. The high number of channels means that moisture is adsorbed with extra efficiency.
Dehumidifier Recusorb R-51/61R technical data:
| Dehumidifier model | R-51 R |
R-61 R |
| Nominal capacity (lbs/h) | 16 | 22 |
| Dry air flow (CFM) | 740 | 850 |
| Static pressure at disposal (in w.c) | 0.4 | 0.4 |
| Wet air flow (CFM) | 250 | 340 |
| Static pressure at disposal (in w.c) | 1.2 | 0.8 |
| Heater power (kW) | 9 | 13.5 |
| Total power (kW) | 10 | 15 |
| Full load current 480V/60Hz (A) | 14 | 19 |
| Supply fuse 3 x 480V/60Hz (A) | 20 | 30 |
| Weight (lbs) | 231 | 243 |
